14 | P a g e
• HIGH SALT: When illuminated, the salt level is too
high, and Excelpool System has shut down. The pool
water must be diluted with fresh water before operation
is restored.
• INSPECT CELL: If flashing, either the cell efficiency is
reduced, or it is time for regularly scheduled cell
inspection. In either case, inspect the cell and clean if
necessary. Pressing the “diagnostic” button next to the
display for 3 seconds will stop the flashing LED. When
illuminated steady, cell efficiency is greatly reduced, and
Excelpool System has stopped producing chlorine.
Inspect, clean or replace if necessary.
SALT DISPLAY
The Salt Display shows the current salt concentration of the
pool water. Readings are in ppm (parts per million). If Metric
units (grams per liter) are preferred, push the “diagnostic”
button next to the display once. The display will now show
the pool water temperature in degrees Fahrenheit. With the
temperature displayed, move the main switch from AUTO to
SUPER CHLORINATE to AUTO. The temperature display
will instantly change to degrees Celsius. Repeat this process
to switch back to USA units (Fahrenheit).
Diagnostic Displays
Sequential pushes of the small "diagnostic" button next to the
LCD display will cause the Excelpool System to display the
following information:
1. Pool temperature (xx degrees Fahrenheit or Celsius)
2. Cell voltage (typically 21.0 to 27.0 volts when
chlorine is being generated, otherwise 16-25V)
To Next Page
Loading...