15 | P a g e
3. Cell current (typically 2.50 to 7.80 amps when
chlorine is being generated, otherwise 0 amps)
4. Desired Output % ("0P" -- "100P" depending on knob
position or input from remote pool automation controller)
5. Instant salinity ( -xxxx ppm or -x.xx grams/Liter)
6. Product name sent to the pool automation control
display
7. Software revision level
8. Cell type.
On the 8th push of the button the display will revert back to
the default salt display. Also, if the button is not pushed for
30 seconds, the display will revert back too.
• Filter time each day (hours)
• The amount of salt in the pool
• The “Desired Level %” setting
• Stabilizer level in the water.
OPERATION
By familiarizing yourself with the operation of the Excelpool
System generator, you can achieve maximum performance for
your pool. When chemical levels are in the recommended range,
there are four factors that you can control which directly
contribute to the amount of chlorine the Excelpool System will
generate:
To Next Page
Loading...