Exibel BIT100 - Connecting the earphones to a Bluetooth device (Pairing)

4 5
English
Connecting the earphones to a Bluetooth
device (Pairing)
Before using theearphones they must be paired with aBluetooth
device. Thetwo devices only need to be paired once.
1. With the earphones switched off, hold in both multifunction
buttons simultaneously for approx. 3 seconds until the LED
indicators start to flash blue or you hear the voice message
“Power on, Pairing”.
2. When the left earphone stops flashing blue and the right
earphone starts to flash red/blue or when you hear the voice
message “Connected right channel/Connected left channel”,
the two earphones have detected each other.
3. Activate Bluetooth mode on theexternal device that you want
to connect theearphones to. Search for theearphones in your
Bluetooth device (refer to themanual for your device).
4. Theearphones will appear on your device as “Exibel BIT100”.
Select them to pair with thedevice.
5. When thepairing has been successful, theright earphone will
stop flashing red/blue and thevoice message “2nd device
connected” will be heard.
Information
• For phone calls, only theright earphone is used. Theleft
earphone is silent.
• Theearphones will automatically re-connect with thelast
Bluetooth device they were paired to.
• If you have connected amobile phone to theearphones and
receive acall whilst you are listening to music, themusic will
be switched off automatically. Once thecall has ended, music
playback will be resumed (if your phone settings enable this).