Need help?Do you have a question about the Exide 12/3.8 and is the answer not in the manual?
General| Battery Voltage | 12V |
|---|---|
| Charging Current | 3.8A |
| Input Voltage | 220-240VAC |
| Cooling | Natural convection |
| Operating Temperature | 0°C to +40°C |
| Input Frequency | 50/60Hz |
| Output Current | 3.8A (max) |
| Battery Type Compatibility | Lead-acid (Wet, MF, AGM, GEL) |
| Protection Features | Reverse polarity protection, Overcharge protection, Short circuit protection |
Connect the mains plug of the charger to a power socket.
Connect red clamp to positive (+) and black clamp to negative (-) battery terminals.
When the green lamp shines, the battery is fully charged.
Read and follow all safety notes and stated precautions before use.
Plug the charger's mains plug into a power socket.
Attach red clamp to positive (+) and black clamp to negative (-) battery terminals.
LED flashes orange for 3 seconds upon correct connection, then turns solid orange.
A constant green light indicates the battery is fully charged.
Charging can be interrupted at any time by unplugging the charger from the power socket.
Unplug the mains, then disconnect the cable clamps from the battery terminals after charging.
Red LED indicates incorrect cable connection to battery terminals.
No charging start or orange LED indicates low battery voltage or fault.
Charging stopped with red LED indicates battery fault or short circuit.
To Next Page
