Need help?Do you have a question about the Exide 12/7 and is the answer not in the manual?
General| Voltage | 12 V |
|---|---|
| Battery Type | Lead Acid |
| Input Voltage | 220-240 V AC |
| Output Voltage | 12 V DC |
| Protection | Overcharge protection, Short circuit protection |
| Charging Time | Varies based on battery capacity |
Connect the charger's mains plug to a power socket.
Connect the red clamp to the positive (+) and black clamp to the negative (-) battery terminals.
Choose the correct mode, battery size (Ah), and technology (AGM/GEL or standard).
The green lamp indicates the battery is fully charged for the selected mode.
Thoroughly read safety notes and user guide instructions before use.
Connect charger to mains, then battery terminals, observing polarity.
Choose battery type/size or supply mode; charging starts automatically.
Observe LED indicators: yellow for charging, green for complete.
Remove cables or leave for maintenance; unplug from mains for storage.
Indicates incorrect cable connection or polarity reversal.
May be due to low battery voltage or faulty battery.
Possible causes: battery fault, parallel load, or battery too large.
To Next Page
