Exile EXMC1 User Manual (English)

To Next Page

Certication Number

QD025389

EXMC1 Owner’s Manual

Bluetooth® Digital Media Center

PAIRING YOUR DEVICE VIA BLUETOOTH®

(REQUIRED FOR OPERATION):

1. Ensure your streaming device has Bluetooth® enabled and

that power is applied to the EXMC1. (The red LED indicates the

EXMC1 is powered on and the blue LED will blink blue to indicate

it is in pairing mode.)

2. Within your streaming device’s Bluetooth® setup menu, select

“EXILE-BT2” from the list of pairable devices. No Pin Code is

required.

3. When successfully connected, the Blue LED on the EXMC1 will

stop blinking and remain lit. Once a device is paired then each

time the device is seen by the EXMC1 it will automatically

reconnect to that device. If no devices are present the EXMC1

automatically goes into pairing mode and will present itself as

discoverable for the next device present.

Need help?

Do you have a question about the Exile EXMC1 and is the answer not in the manual?

Exile EXMC1 Specifications

General

Steps to enable Bluetooth on your device and connect to EXILE-BT2, including LED indicators and automatic reconnection.

Visual guide to EXMC1 buttons, LEDs, and wiring harness connections including power, ground, and audio outputs.

Guide for installing the EXMC1 via a 1 1/8" diameter hole, including gasket and locking nut adjustments.

Instructions for powering the unit on/off using the Power/Aux button and connecting power wires.

Details on connecting the remote in/out wires for synchronized power control with head units or amplifiers.

How to connect media players via 3.5mm jack and switch between Bluetooth and AUX sources using the Power/Aux button.

Details on warranty period, coverage for defects, replacement policy, and validity for original purchasers in the USA.

Acknowledgement of ownership and licensing for Bluetooth and aptX trademarks used in the manual.