Exmark 4500-370 - Product Overview; Operation; Adjusting the Cutting Height; Deck Raising and Lowering

Operation
ProductOverview
Figure7
1.Cutheightadjustment3.Decklifthandle
2.Casterwheel
Operation
AdjustingtheCuttingHeight
Thecuttingheightofthemowerdeckisadjusted
from1to4inches(2.5cmto10.2cm)in1/4inch
(.63cm)increments.
1.Stopthemachineandmovethespeedcontrol
leverstotheneutralposition.
2.DisengagethePTO.
3.Engagetheparkbrake.
4.Stoptheengine,removethekeyandwaitforall
movingpartstostop.
5.Movecotterpinsonfourdecksupportpinsto
properholeforheightofcutdesired.
DeckRaisingandLowering
RaisingtheMowerDeckintoService
Position
1.Stopengine,waitforallmovingpartstostopand
removekey.Engageparkingbrake.
WARNING
Incorrectlyraisingorloweringamowerdeck
canbedangerous.Adroppedmowerdeck
canresultinaseriousinjuryorproperty
damage.
•Alwaysraiseandlowerdeckonat,dry
ground,freeofanyobstructions.
•Firmlygraspthedecklifthandleand
lowerinaslowcontrolledmanner.
•Alwaysmakesurethedeckissecurely
latchedinthe“up”or“down”position.
2.Releasethedecklockingpinsoneachside
(Figure8).
11