Exodraft RSV - User Manual

Other manuals for Exodraft RSV

Installation And Operation Manual12 pages

Questions and Answers

J
Joseph KramerJul 29, 2025
How to troubleshoot an Exodraft RSV Fan that is not operating?
- L
  Laura MathewsJul 29, 2025
  If the Exodraft Fan is not operating, first check the power supply wires in the junction box by the fan. Then, check the circuit breaker to ensure it hasn't tripped. Finally, verify that the fan is actually turned ON.
C
Christina SmithAug 2, 2025
Why is my Exodraft RSV Fan so noisy?
- S
  Savannah HughesAug 2, 2025
  If the Exodraft Fan is noisy, first check if a transportation device has not been removed. Also, turn off the power and remove any foreign matter stuck in the fan. Turn off the power, wait for the motor to stop revolving, spin the wheel, and listen for any grinding noise from the motor. If necessary, replace the bearing.
C
Cody DanielsAug 7, 2025
What to do if my Exodraft Fan is humming or not running at full speed?
- R
  robertscarolAug 7, 2025
  If the Exodraft Fan is not running at full speed or is humming, the capacitor might be improperly connected or not connected at all (single-phase fans only). Check the connections inside the junction box and ensure the capacitor is installed according to the wiring diagram.
A
Ashley RodgersAug 12, 2025
Why is my Exodraft RSV vibrating so much?
- M
  millsangelaAug 13, 2025
  If the Exodraft Fan is vibrating vigorously, turn the power off immediately. Open the fan and check if the shaft is straight. If not, contact ENERVEX at info@enervex.com or at tel.: 1-800.255.2923. Also, turn off the power and remove any foreign article.
D
Donald MullinsAug 17, 2025
What to do if Exodraft RSV stops during firing cycle?
- C
  Carmen PopeAug 17, 2025
  If the Exodraft Fan stops in the middle of a firing cycle, the motor may be overheating. Check the flue gas temperature below the fan; it should not exceed 482°F during continuous operation. Call exodraft at tel: +45 7010 2234.
M
marisacalderonAug 22, 2025
Why is my Exodraft RSV rotating backwards?
- M
  Megan HayesAug 23, 2025
  If the Exodraft Fan (RSV 400/450 only) is rotating backwards, the phase sequence in the power to the fan is reversed. Swap two phases in the junction box to correct this.