Exodraft RSV - Technical Specifications

UK
|
9
3112001_RSV_UK
Technical specications
The RSV fan is designed for vertical discharge. It is available in ten sizes.
The body and casing are manufactured in cast aluminium and equipped with a stainless steel axial vane or
a cast aluminium impeller.
Chimney fan Axial vane/Impeller
RSV009-41
RSV012-41
RSV014-41
RSV016-41
Stainless steel axial vane
RSV160-41
RSV200-41
RSV250-41
RSV315-41
RSV400-41
Cast aluminium impeller
RSV400-42
RSV450-42
Cast aluminium impeller
RSV250-43
RSV315-43
RSV400-43
Cast aluminium impeller
All models can be opened for service and cleaning purposes.
The sound level is below 60 dB (measured at a distance greater than 2.5 metre away from the fan) if
installed correctly. Further information about sound levels available in our technical brochure/datasheet.
The RSV fan has been designed to tolerate ue gas temperatures up to 250°C. Should the temperature be
higher (though maximum 300°C), the mineral wool mat should be removed and replaced with optional
dilution bolts (type RSD) or vibration dampers (type SVD-RS) at the ange to create extra cooling air under
the fan. For more information about these parts see under accessories.
All RSV models has a motor capacitor. The capacitor is considered a wear part that will be worn out over
time (depending on usage). If the capacitor is worn out, the motor will have difculties starting up. Then it is
time to replace the capacitor. Please ask a qualied electrician to carry out this job.