ENG
Pinless Moisture Meters
MC-160SA
Manual
ENG
- 5 -
ENVIRONMENT PROTECTION
According to the regula ons for ba ery dispose, all
ba eries must be returned to the trade or to ba ery
collec ng points. You are not allowed to dispose ba eries
through the household waste.
ONLY FOR EU COUNTRIES
Do not dispose of electrical tools together with household
waste material! In observance of European Direc ve
2002/96/ EC on waste electrical and electronic equipment
and its implementa on in accordance with na onal law,
electric tools that have reach the end of their life must be
collected separately and returned to an environmentally
recycling facility.
SELECTION OF WOOD GROUPS OR BUILDING
MATERIAL GROUPS
A er the unit has been switched on the wood density
200-1100 kg/m3, or building material E0 - E5 is
indicated on the Display.
If this key is kept pressed, the group increases by itself
automa cally while increasing the velocity, as longer it is kept pressed. Or a er
releasing and pressing the key E repe vely, the wood group will increase by
100kg/m³ or the next Material group is selected. A er 2 sec. the unit is ready
to take measurements. The indicated wood group is equivalent to the density
of the mber.
For a wider selec on of wood materials, please see the Wood Group Table at
the end of the manual.
MATERIAL CODE
200 Balsa, Sugi
300 Aspen, Cypress, Cedar
400 Fir, Poplar, Pine, Alder, Small Leaved Lime tree
500 Maple, Larch, Douglas Fir
600 Oak, Birch, Beech, Pear, Teak
700 Silver Birch, Hickory, Wengé
800 Stone Oak, Zebra
900 Boxwood, Rosewood
1000 Ebony
E0 Gypsum fi ber board
E1 Breezeblock
E2 Plaster, Wall Tiles, Brick
E3 Anhydride, Floor Covering, Asbestos, Clinker, Sand
E4 Concrete, Cement screed
E5 Marble
To Next Page
Loading...
Need help?
General
