Exploranium KT-9 - Page 67

59
SCAN
7
—remote control & data storage
The
S
CAN7
program allows you to collect a continuous stream of
data from either core samples or rock faces for later analysis.
This program puts the KT-9 into the
S
CAN
mode, transfers the
measured data to the computer and stores the data into a file.
The KT-9 is completely controlled from the computer in this
configuration. You can also annotate individual profiles or data
segments before they are stored in the data file.
The procedure for running the scanning program is as follows:
1
Connect the supplied cable (Part no. 97945) to the KT-9
computer port located on the bottom panel (covering the
battery compartment).
2
Connect the other end of the cable to the
COM
1:
serial port
of your computer. Please note that the cable has a DB-9
connector. If your computer has a 25-pin ports you will
either need a DB-9 to DB-25 adaptor or ask
EXPLORANIUM
for a special DB-25 version of the connector cable.
3
Turn on the KT-9.
4
Select either the
N
O
-P
IN
(nP) or
C
ORE
(Cor) measuring
modes.
5
Erase all old data in the KT-9’s memory.
6
Run the
S
CAN7
program on your computer.
59
SCAN
7
—remote control & data storage
The
S
CAN7
program allows you to collect a continuous stream of
data from either core samples or rock faces for later analysis.
This program puts the KT-9 into the
S
CAN
mode, transfers the
measured data to the computer and stores the data into a file.
The KT-9 is completely controlled from the computer in this
configuration. You can also annotate individual profiles or data
segments before they are stored in the data file.
The procedure for running the scanning program is as follows:
1
Connect the supplied cable (Part no. 97945) to the KT-9
computer port located on the bottom panel (covering the
battery compartment).
2
Connect the other end of the cable to the
COM
1:
serial port
of your computer. Please note that the cable has a DB-9
connector. If your computer has a 25-pin ports you will
either need a DB-9 to DB-25 adaptor or ask
EXPLORANIUM
for a special DB-25 version of the connector cable.
3
Turn on the KT-9.
4
Select either the
N
O
-P
IN
(nP) or
C
ORE
(Cor) measuring
modes.
5
Erase all old data in the KT-9’s memory.
6
Run the
S
CAN7
program on your computer.