Exploranium KT-9 - Page 68

60
SCAN
7—remote control & data storage
A typical session follows and is shown in Figure 16:
Figure 16
Sample session using S
CAN7
a)
You will be reminded to connect the KT-9 to the com-
puter, turn on the KT-9, select either the
N
O
-P
IN
or
C
ORE
measuring modes and to erase all old data from the
KT-9’s memory.
b)
When you are ready to proceed, press the
K
key on
the computer.
c)
You should then see:
*** KT-9 READY ***
This messages indicates that the computer is properly
talking to the KT-9 and there are no problems.
d)
You will now be asked where you want to store the
data that the KT-9 will be sending:
Enter name of file DEV:FILENAME.EXT
e)
Enter a proper
DOS
filename with the full path, for
example:
D:\KT9DATA\SAMPLE1.DAT
, and press
K
.
Remember that
DOS
only accepts a filename consisting
of 8 characters and 3 extent characters. Also, if no
drive or directory is specified, then the current drive
and directory that you were in (when you started the
S
CAN
7
program) will contain your data file.
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement
60
SCAN
7—remote control & data storage
A typical session follows and is shown in Figure 16:
Figure 16
Sample session using S
CAN7
a)
You will be reminded to connect the KT-9 to the com-
puter, turn on the KT-9, select either the
N
O
-P
IN
or
C
ORE
measuring modes and to erase all old data from the
KT-9’s memory.
b)
When you are ready to proceed, press the
K
key on
the computer.
c)
You should then see:
*** KT-9 READY ***
This messages indicates that the computer is properly
talking to the KT-9 and there are no problems.
d)
You will now be asked where you want to store the
data that the KT-9 will be sending:
Enter name of file DEV:FILENAME.EXT
e)
Enter a proper
DOS
filename with the full path, for
example:
D:\KT9DATA\SAMPLE1.DAT
, and press
K
.
Remember that
DOS
only accepts a filename consisting
of 8 characters and 3 extent characters. Also, if no
drive or directory is specified, then the current drive
and directory that you were in (when you started the
S
CAN
7
program) will contain your data file.
G:\XPLRANUM>scan7
*** SCAN MODE OF KAPPAMETER KT-9 ***
CONNECT KT-9 TO COM1 OF PC-COMPUTER
SWITCH KT-9 ON
SELECT MEASURING MODE ’nP’ OR ’Cor’
ERASE ALL DATA FROM MEMORY OF KT-9 - press ENTER on PC
*** KT-9 READY ***
Enter name of file DEV:FILENAME.EXT mydata.dat
File mydata.dat opened for input
Enter HEADER of measurement FIRST Measurement