Page 11
INFORMATION ON RESIDUAL RISKS:
Expressweld MasterMIG 500W
When working above floor level, use related warning signs to prevent splashing of
melted metals and welding sparks on people under working area.
Electromagnetic fields may be hazardous for pacemakers.
Make the necessary warnings and use warning signs for other people working or
passing around who are not related to welding work. Inform them that they have to
contact with their doctors before working in a welding environment.
In welding environments there is high electric shock risk. Other people may encounter
electric shock risk by tripping over cables while working. Do not use uninsulated
welding cables, route cables through insulated, plastic channels if available.
Expressweld MasterMIG 500W welder has been designed and manufactured in
compliance with safety rules required by TS EN 60974-1 standard. To eliminate the
safety risks all necessary precautions have been taken, precautions that need to be
taken by operator and users and all rules to be followed have been stated in the user
manual. It is not possible to eliminate the risks in cases that necessary care is not
taken or safety measures are not used. These risks may cause slight injuries but at the
same time fire and explosion risks may be fatal for more than one people. It is the
user s responsibility to assure the safety of welding environment, in cases that
precautions are not used or lacking, work must be stopped immediately and authorized
people should be informed.
'
To Next Page
Loading...