EXTENDGROUP EKH-455 - User Manual

Questions and Answers

F
Frederick WhitakerAug 2, 2025
What to do if my EXTENDGROUP EKH-455 has an incomplete seal?
- A
  Autumn MartinezAug 2, 2025
  To address an incomplete seal issue with your EXTENDGROUP Packaging equipment, first, inspect the sealing blades and Teflon tape, ensuring they are clean. If necessary, clean and lubricate them with silicone. Next, check the Teflon tape for any signs of burning or wear, and replace it if needed. Finally, examine the silicone rubber in the top jaw (beneath the Teflon tape); if you find it cut or damaged, replace it.
J
jonathan01Aug 7, 2025
How to fix failure to cut film cleanly in EXTENDGROUP EKH-455 Packaging equipment?
- S
  Sara GrossAug 7, 2025
  If your EXTENDGROUP Packaging equipment is not cutting film cleanly, the sealing blades might be dirty, or the seal time could be too low. Check the clamps of the sealing wire to ensure it's intact; replace it if broken. Then, adjust the settings according to the type of film you're using.
B
Benjamin RussellAug 12, 2025
Why are the heaters not operating on my EXTENDGROUP EKH-455?
- H
  Heidi DeckerAug 12, 2025
  If the heaters on your EXTENDGROUP Packaging equipment aren't working, check if the toggle switch is set to seal only and whether the temperature controller is set too low. Also, the temperature controller, thermocouple, or heating elements may be defective.
N
navarrokevinAug 17, 2025
How to fix the hood if it won’t stay open on EXTENDGROUP EKH-455?
- K
  Kristina BrownAug 17, 2025
  If the hood of your EXTENDGROUP Packaging equipment won’t stay open, it could be due to a torsion bar that is out of adjustment or broken. Consider replacing the torsion bar.
M
Mike BlakeAug 22, 2025
What to do if the packaging is awollen after shrink-wrapping with EXTENDGROUP equipment?
- S
  Samantha CampbellAug 22, 2025
  If the packaging on your EXTENDGROUP Packaging equipment is awollen after shrink-wrapping, make the film pass through the Micro-piercing device of the machine.
S
Sean MartinAug 27, 2025
What to do if the hood won’t stay open completely on EXTENDGROUP Packaging equipment?
- P
  Pamela PenningtonAug 27, 2025
  If the hood on your EXTENDGROUP Packaging equipment won’t stay open completely, tighten the special screw.