Need help?Do you have a question about the Extraflame BELLA LUX and is the answer not in the manual?
General| Type | Pellet stove |
|---|---|
| Flue Outlet Diameter | 80 mm |
| Remote Control | Yes |
| Heating Capacity | 9.5 kW |
| Power Output | 9.5 kW |
| Fuel Type | Pellets |
| Control | Digital |
Form for recording details of the authorized specialist for the stove.
Guidance on storing pellets to ensure proper combustion.
Key safety rules to be followed during stove operation and installation.
Describes the safety action if the warm air blower stops.
Describes the safety action if the fume exhauster stops.
Describes the stove's operation if the pellet feed motor fails.
Explains display messages and checks for lighting failures.
Explains automatic restart after a brief power interruption.
Details the stove's protection against power surges.
Describes safety measures for exhaust system failures.
Explains the safety device for pellet overheating.
Definitions of technical terms used in the manual.
Requirements and guidelines for assembling exhaust channels and pipes.
Specifies the necessary characteristics for chimneys or single flues.
Details the specifications for the chimney cap's design and placement.
Specifies requirements for external air intakes to ensure proper operation.
Recommendations for piping characteristics for the Divina Plus model.
Step-by-step instructions for fitting the insert using the sliding base.
Instructions for installing the insert using an optional pedestal.
Steps for removing the insert for maintenance or repair.
Specifies required measurements for air intakes for circulation.
Explains how to manage warm air convection from the insert.
Describes the operation of the tangential fan for forced ventilation.
Specifies the need for an air entrance hole for convection.
Highlights features like the pellet feeding drawer and component access.
Overview of buttons, displays D1/D2, and their functions on the control panel.
Details common display messages, their causes, and solutions.
Lists alarm messages, their causes, and recommended actions.
Explains the meaning and function of each LED indicator light on the panel.
Essential guidelines for initial stove operation and safety.
How to operate the stove during normal use and adjust settings.
How to use and set the digital room thermostat.
Information and installation of an optional mechanical thermostat.
Electrical schematic showing connections for the general stove model.
Electrical schematic specific to the Maxi Comfort Insert model.
Setting up timed heating periods for each day of the week.
Setting different temperatures for day and night periods.
Adjusting the percentage of pellet feed for optimal combustion.
Parameters for controlling the heat distribution motor in Divina Plus models.
Instructions for setting day and night temperature periods and values.
Explains problems related to pellet feed and how to adjust settings.
Parameters for start/stop and speed adjustment of the heat distribution motor.
Cleaning procedures for Ecologica and Maxi Comfort Insert models.
Monthly cleaning of heat exchangers and periodic check of seals.
Daily cleaning of burn pot, scrapers, and ash drawer for specified models.
Monthly cleaning of heat exchangers and periodic check of seals for specified models.
Daily cleaning of burn pot, scrapers, and ash pans for specified models.
Monthly cleaning of heat exchangers and periodic check of seals for specified models.
Cleaning procedures for burn pot, scrapers, ash pans, and heat exchangers.
Checking and replacing seals on doors, ash drawers, and burn pots.
Instructions for cleaning the chimney duct annually or as needed.
To Next Page
