4 When the bracket is aligned with the rail again, both clamping tabs are positioned on the T-bar rail
lips. Figure 7 shows a mounting bracket, with an AP attached, firmly mounted on a drop-ceiling T-
bar rail. Tap the AP to verify it is stable and won't fall o.
Figure 7: AP and Mounting Bracket Seated on T-bar Rail
5 Make a hole through the ceiling panel closest to the connector bay on the AP. Then run the Ethernet
cable through the hole and into a LAN port (RJ45 Ethernet port) in the connector bay.
6 Replace the displaced ceiling panels.
Mounting the WS-AP3825 to a Wall or Solid Ceiling
Screws for attaching the AP to a wall or solid ceiling are supplied with the product. Use the following
procedure to mount the AP3825 to a flat wall.
1 Determine the spot where the AP is to be mounted, preferably high up on the wall (near the ceiling
for maximum radio wave dispersion) but in reach of the Ethernet cable and a wall power outlet if
you are not able to use Power over Ethernet.
Installation
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version . 18
To Next Page
Loading...
