2 Drill two holes in the wall to match the center of the two keyhole slots in the back of the AP. The
location of the holes is depicted in Figure 8 (measurements are in millimeters). For a tight fit, the
holes should be slightly smaller than the diameter of the provided plastic anchors.
Figure 8: Drilling Template for Wall Mounting
3 Tap the plastic anchors into the holes with a hammer until they are flush with the wall, and screw the
provided mounting screws into the anchors, with the head protruding 1/16" from the anchor.
Installation
ExtremeWireless™ WS-AP3825i & WS-AP3825e Installation Guide for version . 19
To Next Page
Loading...
