1 Install the WS-MBI-WALL04 bracket on a wall/ceiling with the two screws and screw-in anchors.
Ensure that the locking tab on the WS-MBI-WALL04 bracket is on the bottom side during
installation.
Figure 3: Mounting the AP using the WS-MBI-WALL04 Bracket
•
Use the WS-MBI-WALL04 as a template and mark the holes to be used to mount the AP. It is
recommended to use the holes marked "A" or "B".
•
Drill the holes and attach the bracket using the screws and screw-in anchors.
Note
When using the "A" or "B" holes, if the holes are not near the corners of the bracket, you
can break o the corner to decrease the bracket's visibility once the AP is installed.
2 Connect the LAN/Ethernet cable to the AP.
Installation Process
ExtremeWireless™ AP3915i FCC/ROW Installation Guide 11
To Next Page
Loading...
