Confidential and proprietary information of Extreme Networks. © 2011 Extreme Networks, Inc.
All rights reserved. DRAFT. October 20, 2011
Summit Family Switches Hardware Installation Guide
285
5 Carefully slide the power supply the rest of the way out of the switch.
Power supplies may become very hot during operation. Wear thermal protective gloves when you
remove a power supply from an operating switch.
If you are not installing a replacement power supply, install a cover over the unoccupied power supply
bay. Unoccupied bays must always be covered to maintain proper system ventilation and EMI levels.
6 Verify that the replacement power supply is oriented the same way as the unit you removed.
For a Summit X670 series switch, verify that the airflow direction of the power supply matches the
airflow direction of the switch.
7 Carefully slide the power supply all the way into the power supply bay (see
Figure 232). Push the
power supply in until the latch snaps into place.
Figure 232: Installing a Summit 450 W AC Power Supply
Do not slam the power supply into the switch.
8 Connect the power cord to the power supply and to a grounded AC power outlet.
Always be sure that the source outlet is properly grounded before plugging the AC power cord into
the AC power supply.
9 If the power supply is equipped with a power cord retainer, use the retainer to secure the power
cord to the power supply.
To Next Page
Loading...
