Extron electronics IPCP Pro 550 - Device Control

11
All models (single- or dual-NIC)
Each NIC of the control processor is assigned a unique user hardware ID number (MAC address)
(for example, 00-05-A6-05-1C-A0). You may need this address during control processor
configuration. A label that indicates the MAC address is located on the rear or side panel of the unit.
Some models, such as the IPCPPro360, offer Power over Ethernet+ (PoE+) output on RJ-45 connectors
labeled “PoE+ Out,” which can output a maximum of 30watts per port. The corresponding Power LED lights
when the port provides power. For details, see the Global Configurator Help file.
ATTENTION:
• Power over Ethernet (PoE) is intended for indoor use only. It is to be connected only to networks or
circuits that are not routed to the outside plant or building.
• L’alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur uniquement. Elle doit
être connectée seulement à des réseaux ou des circuits qui ne sont pas routés au réseau ou au
bâtiment extérieur.
Control, Unidirectional — IR/Serial
IR/SERIAL
5678
2134
IR/S
1
2
IR/SERIAL
1
SG
2
SG
IR/SERIAL
SGSG SGSG
SGSG SGSG
1 2
5 6
3 4
7 8
Rear Panels Front Panels
To the IR Receiver of a
Projector, Display, or
Source Device
S
G
(-)
(+)
(-)
(+)
(+)
(-)
Two Single IR Emitters
Ground
IR Output Signal
Unidirectional
IR
IR or RS-232
Output
Ground
To a Projector,
Panel Display, or the
Wired IR Remote or
RS-232 Port of a
Source Device
IR/Serial LEDs
Light when signals are transmitted
on the corresponding IR/serial port.
IR/Serial Ports
Output options:
• IR (30 kHz to 300 kHz,
with or without carrier signals)
• Unidirectional RS-232
or or
or
Control, Unidirectional — Relays
RELAYS
2143CC
RELAYS
1 2
5 6
3 4
7 8
RELAYS
5678
2134
Rear Panels
Front Panels
Normally
Open (2)
Common
Normally
Open (1)
Common
To Room
Control
Equipment
To Room
Control
Equipment
Closed
Normally
Open
21C
21C
Relays
• Connect devices for contact control.
• Do not exceed a total of 24V at 1A for each port.
or
Common
Relay 2
Relay 1
All relays
are
normally
open.
Relay LEDs
Light when the corresponding relays
are activated (tied to GND, closed).
MAC: 00-05-A6-XX-XX-XX
S/N: ####### E######
00-05-A6-XX-XX-XX
MAC: 00-05-A6-XX-XX-XX
S/N: ####### E######
MAC
Address
PW
R
PoE+ OUT