Ezviz C2c - Page 5

1
Setup
Step 1 Power-on
Plug the power cable into the camera and to the power adapter and then into a power outlet,
as shown in the figure below. The LED indicator will flash red and blue when the camera is
ready for setup.
Step 2 Camera Setup
1. Create an user account
- Connect your mobile phone to Wi-Fi.
- Download and install the EZVIZ app by searching “EZVIZ” in App Store and Google Play
TM
.
- Launch the app and register for an EZVIZ user account following the start-up wizard.
2. Add a camera to EZVIZ
- Log in the EZVIZ app.
- From the EZVIZ app Home screen, tap “+” on the upper-right hand corner to go to the
scan QR code interface.
- Scan the QR Code on the bottom of the camera.
- Enter the verification code located on the bottom of the camera.
- Enter the correct time zone and DST information and tap “Finish” to finish setup.
Power Cable
Power Outlet
Bottom of the Camera