F(x)tec Pro1 - Hearing Aid Compatibility (HAC); Regulatory Information: Canada; ISED Specific Absorption Rate (SAR) Information

pg. 11
Hearing Aid Compatibility (HAC)
The Pro
1
has been evaluated and certied to be compatible with
hearing aids per technical specication ANSI C63.19-2011. There are
two measures of hearing aid compatibility:
M rating, which is a measure of immunity to radio frequency
interference for acoustic coupling hearing aids; and T rating, which
is a measure of performance when used with an inductive coupling
(telecoil) hearing aid.
The Pro
1
is rated M3/T3.
Per FCC rules, a mobile phone is considered hearing aid compatible
if rated M3 or M4 for acoustic coupling or T3 or T4 for inductive
coupling.
The Pro
1
has been tested and rated for use with hearing aids for
some of the wireless technologies that they use. It is important to
try the different features of your phone thoroughly and in different
locations, using your hearing aid or cochlear implant, to determine if
you hear any interfering noise. Please consult your service provider or
FX Technology Limited for information on hearing aid compatibility.
If you have questions about return or exchange policies, consult your
service provider or phone retailer.
The Pro
1
meets the hearing aid compatibility (HAC) requirements set
by the Federal Communications Commission (FCC).
Regulatory information: Canada
Innovation, Science, and Economic Development (ISED) Canada,
Class B
This Class B digital apparatus complies with Canadian ICES-003.CAN
and ICES-3(B)/NMB-3(B).
Notice: The ISED Canada regulations provide that changes or
modications not expressly approved by FX Technology Limited
could void your authority to operate this equipment.
Innovation, Science, and Economic Development (ISED) Canada
Notices
The Pro
1
complies with ISED’s license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. These devices may not cause interference.
2. These devices must accept any interference, including
interference that may cause undesired operation of the device.
The device for operation in the band 5150–5250 MHz is only for
indoor use to reduce the potential for harmful interference to co-
channel mobile satellite systems.
Specic Absorption Rate (SAR) Information
The radiated output power of the Pro
1
is below the ISED radio
frequency exposure limits. This device has been evaluated for and
shown compliant with the ISED Radio Frequency (RF) exposure limits.
This device should be used in a manner such that the potential for
human contact during normal operation is minimized.
When using the device next to your body (other than in your hand
or against your head), maintain a distance of 10 mm from your body,
to be consistent with how the device is tested for compliance with
RF exposure requirements. Ensure that the device accessories, such
as a device case and device holster, are not composed of metal
components.