3
ENGLISH
The automated system consists of a white beam in aluminium,
with reflex reflectors and a steel upright. The operator is located
inside the upright, and consists of a hydraulic control unit and two
plunging pistons which, by means of a rocker, rotate the beam.
The beam stays balanced thanks to a balancing spring assembled
on one of the plunging pistons. The electronic control unit is also
housed in the upright, inside a waterproof compartment.
The system is supplied with an adjustable anti-crushing safety
device. It also includes a device stopping and locking the beam
in any position, and a handy manual release for use in case of
power cuts or faults.
Fig. 1
1 Beam
2 Travel limit mechanical stop device
3 Drive transmission unit
4 Adjustable travel limit cam RH
5 Adjustable travel limit cam LH
6 Rocker
7 LH travel limit device
8 Oil filling plug
9 Breather screw
10 Cooling fins
11 Piston bleed screw LH
12 Plunging piston LH
13 Hydraulic control unit
14 Feeder pipe LH
15 CLOSING by-pass screw
16 OPENING by-pass screw
17 Upright
18 Hole for cables LH
19 Tie rod
20 Foundation plate
21 Hole for cables RH
22 Earth connector securing screw
23 Cable routing sheath
24 Electronic control board
25 Feeder pipe RH
26 Manual release
27
Spring support position length: 460 mm
28 Protective grid for air intakes
29 Plunging piston RH
30 Spring support position length: 400 mm
31 Balancing spring support
32 Balancing spring
33 Piston bleed screw RH
34 Travel limit device RH
35 Balancing adjustment ring-nut
36 Travel limit mechanical stop device
Fig. 2
37 Lock
38 Hatch
39 Protective grid for air intakes
40 Cooling fan
(sonly 620 rapid, 640 and 642)
1. DESCRIPTION AND TECHNICAL SPECIFICATIONS
TAB. 1 Technical specifications (*)
Hood protective treatment Cataphoresis AISI 316 L
stainless steel
Hood painting Polyester RAL 2004
Protection class IP44
Upright dimensions LxHxP (mm) see Fig. 4 and 5
(*) For more details about the selected barrier model,
refer to chapter 12
TECHNICAL DETAILS OF 1400 rpm ELECTRIC MOTOR
Power supply (Vac{+6%/ -10%}/Hz)
230 / 50
Absorbed power (W)
200
Absorbed current (A)
1
TECHNICAL DETAILS OF 2800 rpm ELECTRIC MOTOR
Power supply (Vac{+6%/ -10%}/Hz)
230 / 50
Absorbed power (W)
200
Absorbed current (A)
1
AUTOMATED SYSTEM 630 - 630PLUS - 640
The 630-630 PLUS-640 automated systems weredesigned
andbuilt to control vehicle access.Do not use for any other
purpose.
BARRIER MODEL 630 630 PLUS 640
Power supply (Vac / Hz) 230 {+6%/ -10%} / 50
Absorbed power (W) 220
Absorbed current (A) 1
Type of oil FAAC HP OIL
Oil quantity (Lt) ~ 1.8
Winding heat protection (°C) 120
Anti-crushing system standard by-pass valves
Type of slow-down Electronic
Operating ambient temperature (°C)
-20 / +55
To Next Page
Loading...
