9
71.5
84
360
390
90
90
L
A = L-450
L
ENGLISH
NB.: Dimensions are in mm.
Fig. 25
Fig. 24
Fig. 22
Fig. 23
Fig. 21
To position the fork support foundation plate, refer to fig.23
where:
P1 = barrier foundation plate
P2 = fork support foundation plate
L = beam length (in mm)
A = Distance between foundation plates
SKIRT KIT
The skirt kit increases visibility of the beam.
It is available in lengths 2m and 3m.
IMPORTANT: If a skirt kit is installed, the balancing spring must
be adapted if possible.
The articulation kit makes it possible to articulate the rigid beam
to a maximum ceiling height of 3.2 m.
IMPORTANT: If the articulated kit is installed, the balancing spring
must be adapted if possible.
END FOOT
The end foot allows the beam to rest when closed and thus
prevents the profile bending downward.
IMPORTANT: If a foot is installed, the balancing spring must be
adapted if possible.
FORK SUPPORT
The fork has two functions:
- it prevents the beam, when closed, from bending and splitting
if its end is stressed by extraneous forces.
- it allows the beam to rest when closed and thus prevents the
profile bending downward
11 AVAILABLE ACCESSORIES
ANTI-VANDAL VALVE (Fig. 20a)
It protects the hydraulic system if the beam is forced.
AUTOMATIC EMERGENCY RELEASE (Fig. 20b)
During a power cut, the automatic emergency release allows
you to manually lift the beam without accessing the release lever
of the hydraulic control unit. A hydraulic system guarantees that
the beam is stopped in opening position.
Fig. 20b
Fig. 20a
To Previous Page
Loading...
