5
ENGLISH
ELECTRONIC CONTROL UNIT FOR BARRIERS
USE INSTRUCTIONS - INSTALLATION INSTRUCTIONS
1. GENERAL CHARACTERISTICS
Thanks to its high powered microprocessor, this control unit for barriers offers a wide range of performances and
adjustments/settings. Moreover, it assures a high level of active security through electronic control of power.
A high-tech electronic control constantly monitors the power circuit and comes into action to shut down the control
unit in the event of faults which could jeopardise correct operation of the electronic clutch. The main settings and
operating modes are effected by dip switches. Time and motor power adjustments are effected by trimmers on the
electronic board. 7 built-in LEDS provide an on-going overview of the status of inputs, outputs and any circuit faults.
2. TECHNICAL SPECIFICATIONS
3. CONNECTIONS
3.1 M1 TERMINAL BOARD
3.1.1 Mains
Terminals «17-18» (Neutral-Phase). Power supply 230 V~ - 50/60 Hz.
ATTENTION: to ensure the control unit operates correctly:
1) respecting the connections, Phase / Neutral of power supply, as it has shown on the electronic board
2) earth connection must be made to the “GROUND” terminal.
3.1.2 Flashing-lamp
Terminals «15-16» (Phase-Neutral). Use a flashing-lamp with operating voltage of 230 Vca.
3.2 M2 TERMINAL BOARD
3.2.1 Gearmotor
Terminals «12-13-14» (Open-Com-Close).
ATTENTION: if the gearmotor is not connected or incorrectly connected, the control unit disables itself and this status
is signalled by rapid flashing of the WORK LED.
Notes:
1) To lay electric cables, use adequate rigid and/or flexible pipes.
2) Always separate the connection cables of low voltage accessories from the 230 V~ power cables. To supply power
to the equipment, use cables with minimum diameter of 1.5mm². To avoid any interference, use separate sheaths.
ylppusrewoP .zH06/05-)%01-6+(~V032
rewopdebrosbA W055
daolxamrotoM W005
daolxamseirosseccA Am005cdV42
erutarepmettneibmagnitarepO C°05+C°02-
sesufnoitcetorP 2
scigolnoitcnuF citamotuA/skraP
emitgnisolc/gninepO )dexif(.ces03
emitesuaP ).ces09ot2morf(elbatsujda-remmirT
ecroftsurhT elbatsujda-remmirT
emitgnitratS )dexif(.ces1
emitgnisreveR )dexif(.ces2
remitnoitareleceD )dexif(.ces1
stupnidraoblanimreT
-timilgnisolc-gninepO/sllecotohpgnisolC/gnisolC/gninepolatoT
dnuorG+ylppusrewopsniaMPOTS/hctiws
rotcennoclortnocoidaR dracrevieceroidaR
rotcennoceludoM eludomlortnocrotoM
stuptuodraoblanimreT rotoM/pmalgnihsalF/seirosseccaotylppusrewopcdV42
snoitcnufelbatceleshctiws-piD ruoivahebllecotohpgnisolC/sedomgnitarepO
To Next Page
Loading...