FAAC T-MODE TM R Series - Page 5

ENGLISH
5
3.3 ELECTRIC CONNECTIONS3.3 ELECTRICAL CONNECTIONS
3.3.1 RADIO VERSION
3.3.2 WIND VERSION
a
220 V ~
220 V ~
a
b
YELLOW-GREEN
BLUE
BROWN PHASE
NEUTRALWIRE
PUSH-BUTTON
AUTOMATED SYSTEM CONTROLLED BY REMOTE CONTROL
ONLY:Forthistypeofconfiguration,connecttheblueand
browncablesofthemotortothemainspowersupplyand
theyellow-greencabletoearth.Do not connect the RED
(or black) wire.
Do not cut the red (or black) cable if it is not
used, just insulate it
AUTOMATED SYSTEM CONTROLLED BOTH BY REMOTE
CONTROL AND BY PUSH-BUTTON: For this type of
configuration,connectthemotorasshownintheprevious
diagram,fig.6.
The push-button has a step-by-step logic:
each pressure exerted on the push-button
sends a pulse to the motor (I.E.: FIRST PULSE UP
- SECOND PULSE STOP - THIRD PULSE DOWN etc.).
After a down or up command, the motor stays
active until the relevant travel limit has been
reached.
TheseriesRtubularmotorcanbecontrolledbothbythe
remote control and by a push-button with step-by-step
logic.
TheseriesWtubularmotorcanbecontrolledbothbythe
remote control and by a push-button with step-by-step
logic. In addition,a wind sensor (anemometer) canbe
connectedtothemotor:itcommandstheclosure of the
rolling shutter assoonasthewindhasreachedaspeed
higherthan20Km/h.
WHEN THE ANEMOMETER OPERATES, THE MOTOR
DIRECTION OF ROTATION CORRESPONDS TO THAT
CONTROLLED BY THE UP PUSH-BUTTON OF THE
REMOTE CONTROL. THE DOWN COMMAND IS
INHIBITED FOR 16 min.
AUTOMATED SYSTEM CONTROLLED BY REMOTE CONTROL
AND ANEMOMETER:Forthistypeofconfiguration,connect
theblueandthe brownwire ofthe motortothemains
power,andtheyellow-greenwiretoearth.Donotconnect
thered(orblack)wire.
THEANEMOMETERmustbeconnectedasshowninfigure7.
AUTOMATED SYSTEM CONTROLLED BY REMOTE CONTROL,
PUSH-BUTTON AND ANEMOMETER: For this type of
configuration,connectthemotorasshowninthediagram
offigure7.
Fig.6
Fig.7
YELLOW-GREEN
BLUE
BROWN
RED
(ORBLACK)
PUSH-BUTTON
WHITE
ANEMOMETER
The push-button has a step-by-step logic:
each pressure exerted on the push-button
sends a pulse to the motor (I.E.: FIRST PULSE UP
- SECOND PULSE STOP - THIRD PULSE DOWN -etc.).
After a down or up command, the motor stays
active until the relevant travel limit has been
reached.
Do not cut the red (or black) cable if it is not
used .
RED
ORBLACK
PHASE
NEUTRALWIRE