FAAC T-MODE TM R Series - Page 6

P
P
ENGLISH
6
4 MEMORY STORING THE FIRST RADIO 433Mhz
UP
DOWN
STOP
PROGRAMMING
PUSH-BUTTON
Fig.8
REAR
VIEW
Portable remote control
Wall-mounted remote control
CHANGE RADIO
CHANNEL
ENABLE
DISABLE
SUN SENSOR
MAX. 20 RADIO DEVICES CAN BE STORED IN THE MEMORY OF THE MOTOR INTERNAL RECEIVER (WALL-MOUNTED REMOTE CONTROLS,
RADIO ANEMOMETERS, ETC.). MEMORY STORING CAN OCCUR IN ANY MOTOR STATUS.
According to the configuration of your installation
(Fig.9) observe the instructions given in the following
paragraphs.
1. Supplythemotorwithpower.
2. Within15secondspressthePprogrammingpush-button,
thentheDOWNpush-buttonofthetransmitter.
3. Themotorperformstwobriefmovementsinbothdirections
to confirm the correct programming.Perform some brief
up,stopanddownmovementstocheckiftheoperation
iscorrect.
TYPE 1 and 4
TYPE 2 and 3
1. Supplythemotorwithpower.
2. Within15secondspressthePprogrammingpush-button,
thentheUPpush-buttonofthetransmitter.
3. Themotorperformstwobriefmovementsinbothdirections
toconfirmthecorrectprogramming
4. Performsomebriefup,stopanddownmovementstocheck
iftheoperationiscorrect.
TYPE 1
TYPE 2
TYPE 3
TYPE 4
MOTOR HEAD SIDE
Fig.9