EAVE DETAIL
CE-1
FASTENER
@ 12" C/C
ROOF STRUCTURE
5V ROOF PANEL
BUTYL TAPE
TOP & BOTTOM
INSIDE
CLOSURE
30# ROOFING FELT
#14 FASTENER
ROOFING NAIL
AS REQUIRED
Notes:
1. Tack the eave flashing in place under the
underlayment using a few roofing nails. Fasten
the eave trim to the fascia with a painted screw
fastener @ 12” o.c.
2. Panels should overhang the eave 1”.
VALLEY DETAIL
#14 SCREWS
EACH SIDE OF MAIN
RIBS (EAVE/ENDLAP
PATTERN) AND
ONE ADDITIONAL,
CENTRALLY LOCATED
IN THE PAN OF THE
PANEL.
5V ROOF PANEL
4" MINIMUM
SEALER STRIP,
1"x1"x13'
BLOCK CLOSURE
FILLS RIB VOIDS
ROOF FELT AND
ICE & WATER SHIELD
RV-2
ROOF STRUCTURE
PLYWOOD OR
SOLID SUPPORT
CUT PANEL AS
NECESSARY
BUTYL SEALANT
TOP & BOTTOM
OF SEALER STRIP
Notes:
1. Not all layers of roofing underlayment are
shown.
2. Adhere ice & water shield to decking at valley
location and install a layer of 30# felt.
3. Place a second layer of 36” roofing
underlayment in the center-line of the valley
with 18” of underlayment on each side of the
valley.
4. When valley flashing is overlapped, a minimum
of 6” of lap is recommended with sealant
applied between the pieces of valley trim at the
endlap.
5. Install Butyl Sealant Tape and 1x1x13’ Sealer
Strip parallel to the valley flashing as shown
above.
6. Field cut the roofing panels holding back 4”
from valley as shown.
7. Fasten the panels to the valley flashing as shown
6” on center using the proper fastener.
START GABLE DETAIL
WG-1
SCREW
FASTENER
@ 12" C/C
FASTENER
BUTYL TAPE
30# ROOFING FELT
ROOF STRUCTURE
ROOF PANEL
Notes:
1. Install the gable trim by positioning it into a bead
of sealant over the edge of the roof as shown and
fasten it to the fascia board and the roof deck at
12” on center.
2. The eave end of the gable trim can be closed-off
by snipping and folding.
3. For gable detail at ridge, see next page.
4. When the last roof panel at the gable overhangs
the gable edge, see the Finish Gable Detail, at
right.
FINISH GABLE DETAIL
CUT PANEL AS
NECESSARY
To Next Page
Loading...