Congratulations, you have just purchased a FACNOR furling and reefing system, "the
easiest to install" system available today.
Please take a few minutes to read the following instructions before proceeding, this
furling system has been designed for a simple and quick installation.
Please note that to fit with jib furling system, you need to have a low terminal with Ø
Low terminal with a maximum Ø of 13,6 mm R 80 to R 130
a maximum Ø of 16 mm R 150 and R 200
a maximum Ø de 22,4 mm R 260 and R 290
Ex: manual terminal (norseman, sta-lock…….) or swage rigging screw.
THE FURLING SYSTEM KIT:
- 1
st
parcel: SECTIONS
including - sections
- connectors
- telescopic section
- 2
nd
parcel: BOX
including - drum
- halyard swivel
- bearings
- screws
- top cap
- halyard deflector wheel + red bearings
- feeder
- shackles + Allen keys
- pin
You need the following tools to fit your FACNOR system:
- a screwdriver or electric screwdriver
- a soft head hammer
I. FITTING RECOMMENDATIONS
- first slacken the backstay to allow for the loosened headstay.
- use a genoa or spinnaker halyard to rig temporary the headstay to support your
mast during the installation.
- take out forestay pin at the deck level.
MAKING CERTAIN THAT THE MAST IS SECURE !!!
To Next Page
Loading...
