Need help?Do you have a question about the Facnor LS PLUS and is the answer not in the manual?
General| Brand | Facnor |
|---|---|
| Model | LS PLUS |
| Category | Marine Equipment |
| Language | English |
Inventory of standard components included in the Facnor furling system kit.
Information on the sections and connectors included in the Facnor furling system.
Guidance on selecting the correct length of foil sections for forestay installation.
General comments on the ease of assembly and use of the Facnor furling system.
Instructions and importance of rinsing the furling system for longevity.
Critical safety warnings regarding electrical hazards and mast securing during installation.
Steps and tools required for preparing components before assembling the furling system.
Instructions for assembling the halyard deflector onto the forestay.
Procedure for fitting the top cap and connecting it to the top section.
Guidance on correctly fitting the halyard swivel to the forestay assembly.
Steps for connecting the foil sections together, including the use of bushings and screws.
Instructions on how to install the telescopic section into the lowest foil section.
Procedure for attaching the sail feeder to the telescopic section.
Details on installing the bushing correctly within the telescopic section.
Steps for securely attaching the telescopic section to the drum.
Methods for securing the bottom of the drum, including standard and turnbuckle kit assemblies.
Procedure for tensioning and aligning the foil sections correctly.
Instructions for fixing the sail feeder for different Facnor ranges (LS/RX/RS and LX).
Guidelines for positioning the front deck block for optimal furling line routing.
Steps for tying the reefing line to the drum and ensuring proper tension.
Specific mounting instructions when the deflector wheel is not used.
Adapting the system for sails with a shorter luff, like storm or working jibs.
Steps to remove the furling line guides during the system conversion.
Instructions for removing the half plates as part of the conversion process.
Steps to install half protection rings when converting to headfoil.
To Next Page
