CHRISTEN EAGLE II Instruction Manual.
2
INTRODUCTION.
Thank you for choosing the CHRISTEN EAGLE II ARTF by SEAGULL MODELS. The
CHRISTEN EAGLE II was designed with the intermediate/advanced sport flyer in mind. It is a semi
scale airplane which is easy to fly and quick to assemble. The airframe is conventionally built using
balsa, plywood to make it stronger than the average ARTF , yet the design allows the aeroplane to
be kept light . You will find that most of the work has been done for you already . Flying the CHRISTEN
EAGLE II is simply a joy.
This instruction manual is designed to help you build a great flying aeroplane. Please read this
manual thoroughly before starting assembly of your CHRISTEN EAGLE II . Use the parts listing
below to identify all parts.
WARNING.
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU
ASSUME ALL RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C
supplier and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training
procedures designed to help the new pilot on his way to successful R/C flight. They will also be able
to advise on any insurance and safety regulations that may apply.
ADDITIONAL ITEMS REQUIRED.
0.75-.91 2- stroke engine.
0.91-1.00-1.25 4- stroke engine.
Computer radio with six digital
servos.
Glow plug to suit engine.
Propeller to suit engine.
Protective foam rubber for radio
system.
Silicone fuel line.
TOOLS & SUPPLIES NEEDED.
Thick cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
Thread-lock.
Paper towels.
PARTS LISTING.
FUSELAGE ASSEMBLY
(1) Fuselage.
(1) Canopy hatch.
WING ASSEMBLY
(2) Right wing half with pre-installed
aileron.
(2) Left wing half with pre-installed
aileron.
(2) Aluminium dihedral brace.
Tail section assembly
(1) Horizontal stabilizer with pre-
installed elevator halves.
(1) Vertical stabilizer with pre-
installed rudder halves.
Some more parts.
HARDWARE PACK
COWLING
Landing gear.....
To Next Page
Loading...