fadini COMBI 740 - Manufacturer Declaration of Conformity; Product Compliance and Legislation; Manufacturer Responsibilities and Standards

Via Mantova 177/A - C.P. 126 - 37053 Cerea (VR) Italy
Tel. +39 0442 330422 - Fax +39 0442 331054
e-mail: info@fadini.net - www.fadini.net
Manufacturer:
Model:
The Combi 740 is sold to be installed as an "automated system", with original accessories and components specified
by the manufacturer.
An automation, in legal terms, is a "machine" and therefore all safety regulations must be applied by the installer.
The installer is also required to issue a Declaration of Conformity.
The Manufacturer does not assume responsibility for improper use of the product.
The product conforms to the following, specific legislation:
- Risk analysis and subsequent actions to remove them:...........................................................
EN 12445 & EN 12453
- Low Voltage Directive...........................................................................................................................................2006/95 CE
- Electromagnetic Compatibility Directive..............................................................................2004/108/CE & 92/31 CEE
Address:
CONFORMS TO MACHINERY DIRECTIVE .........2006/42/CE
FURTHER:
In order to certify the product, the Manufacturer declares, assuming sole responsibility, its compliance with
PRODUCT STANDARDS .........................EN 13241-1
Date:
CERTIFIES, ASSUMING SOLE RESPONSIBILITY THAT:
DECLARATION OF CONFORMITY
of the Manufacturer
GB
Meccanica Fadini s.n.c.
Managing Director
Managing Director
ground-installed oil-hydraulic gate opener
03-03-10
s.n.c.
31
English