FAFREES F20 Max - Getting Started

EN
15
QUICK START GUIDE
GETTING STARTED
Figure 1 YL80C display
Button definitions: The YL80C display is equipped with five buttons on the corresponding operating unit:
power button , plus button , minus button , light button and toggle button (the
following is represented by the “i button”).
Press the power button on the display control pad to turn on the bike. To turn off, press and hold the
power button for 3 seconds. The display will automatically shut off if it is not used for more than 10
minutes.
HOME PAGE
DISPLAY CONTROL PAD
1. Display interface switching：When the display is powered on, it will show the Current Speed (km/h)
and Trip Odometer (km) by default. Short press i button to switch between Trip Odometer(km),
Odometer (km), Maximum Speed (km/h), and Average Speed (km/h).
2. Assist level: Use plus/minus button to switch the assist level. Power assist is triggered when you
pedal forward, and stops when you stop pedaling, sometime with a delay.
Battery level
Error code
Current speed
Walk assist mode
Trip odometer
Odometer
Max speed
Average speed
Light ON/OFF
Speed unit
KM/H
MPH
PAS level
Unit
Value