EN
Remove the screws with a hex key. With the mounting holes of the footrests facing forward, align the
mounting holes and tighten the screws. Install the pedal cover, align the mounting holes and tighten the
screws.
Step 8: Wheel reflector installation.
Put the reflector between the spokes. Align the reflector clip with the slot, insert the clip through the
spoke into the slot, and tighten the screw to secure the reflector clip.
Step 9: Adjust the display and the bell.
Adjust the position of the
display and bell and
tighten the screws with a
hex key.
Step 10: Inflate tires.
Check that the tire beads and tires are evenly seated on the rims. Use a pump with a Schrader valve to
inflate each tire to the recommended pressure indicated on the tire. Do not overinflated or underinflate
tires.
BATTERY CHARGING
Charging procedure
Follow these steps for charging your ebike battery from Fafrees Bikes:
1. Ensure the battery is off.
2. Remove the rubber cover on the charging port.
3. Plug the charger into the battery ’ s charging port, BEFORE PLUGGING CHARGER INTO
POWER OUTLET.
With the battery on or off the bike, place the charger in a flat, secure
place, and connect the DC output plug from the charger to the charging
port on the side of the battery.
4. Plug the charger into a power outlet: Connect the charger input
plug (110/240-volt plug) to the power outlet. Charging should initiate and
will be indicated by the LED charge status light on the charger
illuminating as red light.
To Next Page
Loading...
