Fagor 102 - Page 7

GENERAL CARACTERISTICS
101 101S 102 102S
Feedback inputs
Connector A1 (X axis) x x x x
Connector A2 (Y axis) x x x
x5 multiplier circuit for sine-wave signals x x x
Feedback correction factor x x x x
Analog outputs
X axis x x x x
Y axis x x
Spindle (S) x x x x
Axes
X axis x x x x
X + Y axis x x
X axis + electronic handwheel x x x
Axes X + Y + auxiliary handwheel x x x
Double feedback for X axis x
Axis control
Closed Loop x x x x
Open Loop x x
Rigid Tapping x
Interface with external
devices
External operator panel "JOG 100" x x
RS232C Interface x x x
Fagor Local Area Network (LAN) x x x
DNC 100 x x
Operating options
Overtemperature alarm x x x
Operation in radius or diameter x x x
Operation with a probe x x x
Zero offsets x x x
Tool length compensation x x x
Acceleration / deceleration x x x x