Date: March 1995 Software version: 5.3 and newer
FEATURE MODIFIED MANUAL AND SECTION
Management of feedback with coded Io Installation Manual Section 4.6 & 6.5
Spindle inhibit by PLC Installation Manual Section 3.3.9
Handwheel management by PLC Installation Manual Section 3.3.3
Rapid (JOG) key simulation via PLC PLCI Manual
Non-servo-controlled open-loop motors Applications Manual
Function G64, multiple machining in an arc. Installation Manual Section 3.3.9
To be selected by machine parameter.
Initialization of machine parameters after
memory loss.
Date: September 1995 Software version: 6.0 and newer
FEATURE MODIFIED MANUAL AND SECTION
512 Kb of part-program memory Operating Manual Section 3.6
When conditional input (block skip) active
while in JOG mode, the
key is ignored Installation Manual Section 1.3.6
To Next Page
Loading...
