8025/8030 CNC OPERATING MANUAL 29
3.4.1.2. Selection of the program to be executed
Same as section 3.1.1.2.
3.4.1.3. Selection of starting block
Same as section 3.1.1.3.
3.4.1.4. Display of the contents of the blocks
Same as section 3.1.1.4.
3.4.1.5. Cycle start
Same as section 3.1.1.5.
3.4.1.6. Cycle stop
Same as section 3.1.1.6.
3.4.1.7. Change of operation mode
At any time during the execution of a cycle in the DRY RUN operating mode, it can be switched
to the operating modes AUTOMATIC or SINGLE BLOCK. To do this:
- Press OP MODE: The operating mode list will appear.
- Press 0 or 1.
If any number other than 0 or 1 is pressed, the CNC will return to the DRY RUN mode.
To Next Page
Loading...
