30 8025/8030 CNC OPERATING MANUAL
3.4.1.8. Tool inspection
Same as section 3.1.6.
3.4.2. Display modes
Same as section 3.1.2. except BACKGROUND EDITING which is not available.
Regardless of the form of execution selected, the CNC will always examine the program as it
executes it and will indicate possible programming errors.
If during the execution of a program in DRY RUN mode we change to AUTOMATIC or
SINGLE BLOCK mode, one more block is executed in DRY RUN mode before changing
over to the mode selected, recovering in the first block of this new mode the position
corresponding to the point in the program in which the machine finds itself.
In DRY RUN operating mode, by pressing the RESET key twice, the CNC is reset to power-
on conditions. The first time RESET is pressed, the message RESET? flashes at the top
righthand side of the screen; if it is not desired to carry out RESET, press the CL key.
To Next Page
Loading...
