All rights reserved. No part of this documentation may be transmitted,
transcribed, stored in a backup device or translated into another language
without Fagor Automation’s consent. Unauthorized copying or distributing of
this software is prohibited.
The information described in this manual may be subject to changes due to
technical modifications. Fagor Automation reserves the right to change the
contents of this manual without prior notice.
All the trade marks appearing in the manual belong to the corresponding
owners. The use of these marks by third parties for their own purpose could
violate the rights of the owners.
It is possible that CNC can execute more functions than those described in
its associated documentation; however, Fagor Automation does not
guarantee the validity of those applications. Therefore, except under the
express permission from Fagor Automation, any CNC application that is not
described in the documentation must be considered as “impossible”. In any
case, Fagor Automation shall not be held responsible for any personal injuries
or physical damage caused or suffered by the CNC if it is used in any way
other than as explained in the related documentation.
The content of this manual and its validity for the product described here has
been verified. Even so, involuntary errors are possible, hence no absolute
match is guaranteed. However, the contents of this document are regularly
checked and updated implementing the necessary corrections in a later
edition. We appreciate your suggestions for improvement.
The examples described in this manual are for learning purposes. Before
using them in industrial applications, they must be properly adapted making
sure that the safety regulations are fully met.
ORIGINAL INSTRUCTIONS
To Next Page
Loading...