Conversational mode
111
Simulating a cycle.
After editing a cycle, it can be simulated by pressing the
vertical simulation softkey.
The simulation screen displays the following softkeys:
1. Softkey to start cycle simulation.
2. Softkey to stop cycle simulation.
3. Softkey to reset the simulation.
4. Softkey to simulate the cycle block by block.
5. The horizontal softkeys may be used to configure how
to display the simulated cycle:
• Type of view.
• Configuration.
• Actions.
• Delete.
• Dimensions.
• Measurement.
Note: by pressing [CTRL] + [G] zoom into graphic area
to see the entire cycle area.
To Next Page
Loading...
