Measuring and calibration cycles (M)
138
#PROBE 2
Probe calibration.
#PROBE 2 X Y Z B J E H F
X..Y: Real coordinates of the arc center
When these coordinates are programmed,
they are considered the exact coordinates
of the center. If they are not programmed,
the CNC will deem that they are not
accurate and needs the function M19 for a
correct calibration.
Z: Position where probing takes place
B: Safety distance
J: Theoretical diameter of the hole
E: Withdrawal distance after initial probing
H: Feedrate for the first probing movement
F: Feedrate for the second probing
movement
Cycle Meaning
To Next Page
Loading...
