Fagor CNC 8060 - Page 144

Measuring and calibration cycles (M)
144
#PROBE 10
Rectangular part centering.
#PROBE 10 [X Y Z] I J [K] [L] [B] D E [H]
[F] [Q] [C]
X..Z: Probe position when calling the cycle
I: Part length along the abscissa axis
J: Part length along the ordinate axis
K: Axis and direction of the first probing
movement (if K0, in the positive X
direction; if K1, in the negative X
direction; if K2, in the positive Y direction;
if K1, in the negative Y direction)
L: Surface coordinate measurement (if L0,
do not measure the coordinate; if L1,
measure the coordinate)
B: Safety distance
D: Safety distance along Z
E: Withdrawal distance after initial probing
H: Feedrate for the first probing movement
F: Feedrate for the second probing
movement
Q: Feedrate for approach movements
C: Centering type
Cycle Meaning
D
B
E