Work modes
18
Coordinate preset (temporary offset)
The [ESC] key may be used to cancel the operation at any time.
Keyboard.
1. Select the axis to be preset (on alphanumeric
keyboard). The CNC will highlight the coordinate of
that axis.
2. Key in the desired preset value.
3. Press [ENTER] to assume the entered value.
Keyboard (using the calculator).
1. Select the axis to be preset (on alphanumeric
keyboard). The CNC will highlight the coordinate of
that axis.
2. Open the calculator using the [CALC] key or by
pressing [CTRL] + [K]. The value shown by the axis
goes directly into the calculator and any operation
can be performed (for example: /2 [ENTER]).
3. Press the [INSERT] key to directly enter the value of
the calculator for the selected axis.
4. Press [ENTER] to assume the entered value.
Softkey menu.
1. Press the softkey for presetting axes to show the list
of axes of the channel and select an axis. The CNC
will highlight the coordinate of that axis.
2. Key in the desired preset value.
3. Press [ENTER] to assume the entered value.
To Next Page
Loading...
