Fagor CNC 8060 - Page 20

Work modes
20
Set the feedrate, speed or tool
Feedrate.
1. Press [F] at the alphanumeric keyboard.
2. Enter the new feedrate directly or with the calculator
if a calculated value is to be used.
3. Press [START] to assume the entered value or [ESC]
to cancel the operation.
Speed.
1. Press [S] at the alphanumeric keyboard until
selecting the desired spindle. When pressing this key
for the first time, the CNC will highlight the relevant
data indicating that it is selected.
2. Enter the new spindle speed.
3. Press [START] to assume the entered value or [ESC]
to cancel the operation.
Tool.
1. Press [T] on the alphanumeric keyboard.
2. Enter the tool to be selected.
3. Press [START] to assume the entered value or [ESC]
to cancel the operation.
Note: this command initiates a tool change that may
require the movement of axes and mechanical parts of
the machine.