Work modes
31
End simulation and start executing the program.
1. Press the [STOP] of the operator panel to interrupt the
simulation. Once the program is interrupted,
simulation may be resumed with the [START] key or
switch to execution mode from the vertical softkey
menu.
2. When switching to execution mode (after pressing the
softkey), the CNC goes into tool inspection to
reposition the axes, modify program conditions, etc.
To complete the tool inspection and before starting
the execution of the program, the spindle turning
direction must be restored and the axes repositioned.
The vertical softkey menu offers two options.
• Repositioning the axes at the interruption point.
• Repositioning the axes at the starting point of the
interrupted block.
3. Press the [START] key to start the execution.
To Next Page
Loading...
