Work modes
36
Edisimu mode (editing and simulation)
Softkey Meaning
Description of the softkeys of the edisimu mode.
START (simulation).
Starts program simulation or resume it if it was
interrupted.
STOP (simulation).
Interrupt program simulation. Simulation will resume by
pressing the START softkey.
RESET (simulation).
Cancel program simulation. If an error occurs during
simulation, reset eliminates the error status and returns
the simulation mode to its initial conditions.
Change the channel being displayed for editing and
simulation. It does not affect the active channel at the
CNC. (This icon will only be available when the CNC has
channels).
Select the “single block” or “continuous” execution
mode. When "single block" mode is active (the icon will
appear pressed), program simulation will be interrupted
at the end of each block.
Analyze the program looking for syntax errors. The
syntax check is not available for programs written in
8055 CNC language.
Offer an estimate of the total execution time at 100% of
the programmed feedrate. This softkey is only
accessible from the statistics screen and the result is
displayed on the same screen.
Configuring simulation options.
To Next Page
Loading...
