Fagor CNC 8060 - Page 49

ISO language
49
G02
* * Clockwise circular (helical) interpolation.
See:
G06
G261
G262
G02 X...[I] Y...[I] I...J...[Z...] (G17)
G02 X...[I] Z...[I] I...K...[Y...] (G18)
G02 Y...[I] Z...[I] J...K...[X...] (G19)
G02 X...[I] Y...[I] R...
X...Y...Z...: coordinates of the end point of the
interpolation
I...J...K...: coordinates of the arc center (I=X,
J=Y, K=Z)
R...: radius (alternative to I, J, K)
I: incremental
Note: I, J, K are programmed using function G06
or after activating function G261.
G03
* * Counterclockwise circular (helical)
interpolation.
See:
G06
G261
G262
G03 X...[I] Y...[I] I...J...[Z...] (G17)
G03 X...[I] Z...[I] I...K...[Y...] (G18)
G03 Y...[I] Z...[I] J...K...[X...] (G19)
G03 X...[I] Y...[I] R...
X...Y...Z...: coordinates of the end point of the
interpolation
I...J...K...: coordinates of the arc center (I=X,
J=Y, K=Z)
R...: radius (alternative to I, J, K)
I: incremental
Note: I, J, K are programmed using function G06
or after activating function G261.
G04
* Dwell.
See:
#TIME
G04 K...
K...: dwell measured in seconds
G05
* ? * Controlled corner rounding (modal).
See:
G61
#ROUNDPAR
G05
Function M D V Meaning