ISO canned cycles (M)
79
G162
* Multiple machining in a grid pattern.
G162 A B X I K Y J D [P] [Q] [R] [S] [T] [U] [V]
A: Angle, in degrees of the tool path with respect
to the abscissa axis (default = 0).
B: Angle between both tool paths (default value
= 90)
X: Length of the grid
I: Step between machining operations along the
path
K: Total number of machining operations along
the path, including that of the machining
definition point
Y: Width of the grid
J: Step between machining operations along the
path
D: Total number of machining operations along
the path, including that of the machining
definition point
Note: when defining the machining operation,
only two of parameters X, I and K are required.
When defining the machining operation, only two
of parameters X, J and D are required.
Function MDVMeaning
To Next Page
Loading...
