ISO canned cycles (T)
89
G84
* Turning canned cycle for curved sections.
G84 X Z Q R C D [L] [M] [F] [H] I K
X: X coordinate of the profile's starting point
Z: Z coordinate of the profile's starting point
Q: X coordinate of the profile's last point
R: Z coordinate of the profile's last point
C: Machining pass (in radius)
D: Withdrawal distance after each pass
D=0: the tool exit path is the same as the
entry path
D<>0: retracts at 45 degrees
D not programmed: retracts while following
the profile to the previous step
L: Finishing stock on the X axis (in radius)
M: Defines the finishing pass along the Z axis (if
not programmed, a value of 0 will be
assumed)
F: Feedrate for the last roughing pass. If not
programmed or programmed as F0, it does
not run the last roughing pass.
H: Finishing feedrate. If not programmed or
programmed as H0, it does not run the
finishing pass.
I: Distance from the starting point to the arc
center along the X axis
K: Distance from the starting point to the arc
center along the Z axis
Note: The radius compensation must be
G41/G42 before activating G84.
Function MDVMeaning
To Next Page
Loading...
