Fagor CNC 8065 - Manual (Jog) Mode. Tool Calibration; Types of Calibration; Manual Calibration. Calibration without a Probe; Semi-automatic Calibration. Calibration with a Probe

Conversational cycles (T)
131
Profiles.
Point-to-point turning
Profile turning
Profiles and pockets in the
ZC/YZ plane
Profile in the ZC/YZ
plane
ZC/YZ rectangular
pocket
ZC/YZ circular pocket:
ZC/YZ pre-emptied
pocket
ZC/YZ 2D profile pocket
Profiles and pockets in the
XC/XY plane
Profile in the XC/XY
plane
XC/XY
rectangular
pocket
XC/XY circular pocket
XC/XY pre-emptied
pocket
XC/XY 2D profile pocket
NOTE: repetitions can be made for all of the above profile cycles,
except point-to-point turning and profile turning. See page 121.